GeoApps Ideas

When using the oblique/street view modules, the fly-out remains open when the module is closed, meaning it is possible to immediately reopen the module in a new location by clicking in the map. This is by design, but it would be great if it was configurable whether or not fly-outs such as oblique/streetsmart/streetview are immediately closed when clicking on the close button in the top right corner of the modal.

After searching for an address in the map viewer, a marker will appear on the map of the address in question. The marker disappears after approximately 10 seconds. For a closer look at the location in question, it is desirable that the marker remains on the screen longer and/or only disappears during the next action.

Ability to set filters so that they are applied during the initial display of a map (other than with the definition query, this must also be shown in the legend and be able to be disabled like regular filters). Ideally, this can also be user-based.

A feature where, upon clicking on an object in a map layer, only the overlapping objects from all other enabled map layers are displayed (intersect)

In the viewer there are max 5 thememaps being displayed in the list in the top left. It would be good to have a setting to extend this and/or to implement an improved UI displaying there are more thememaps.

The ability to navigate from an app (e.g., Dashboard, MapTour) to the editor and/or the startpage/manage if the user has the necessary permissions. The ability to grant specific users (non-admins) access to the editor of an app.

Voor sommige lagen is het handig om in de titel van de pop-up zowel de naam de laag als een attribuut waarde te tonen.

Bepaalde attributen + bijbehorende waarde gegroepeerd tonen onder een bepaalde titel, maakt het voor de gebruiker overzichtelijker. Het toevoegen van een new line tussen twee velden kan ook helpen.

When LiveTable is applied in a table, for example, the values in the bar chart for non-corresponding values are no longer displayed. However, the associated attribute values remain below/beside the axis. It would be nice if these were also no longer displayed, and the chart was adjusted accordingly after applying the LiveTable filter.

When using a minimum or maximum value in a chart or block, the actual values or objects are still displayed, but they are shown outside the diagram or chart area. It would be nice if the functions also omitted the values outside the min/max values in the display.